Installation guide
Four steps to install the blackout curtains
Step 1: Lay out the frames
- Unpack all parts: Place the top frame, the bottom frame, and the side frames on a clean and flat surface.
- Place the upper and lower frame: Place the upper and lower frame parallel to each other on a horizontal surface
Step 2: Attach the frame connections
Attach a frame connector to one end of the frame with the fabric, and then attach the other connector to the other end.
Step 3: Connect the frames
Connect all frames by attaching the fabric and side frame to the top and bottom frame.
Step 4: Tighten the laces
Pull one slider down inside the frame and push the other slider up to tighten the laces properly.
Four steps for installation
Step 1: Cut the foam tape
Split the included foam tape into two equal parts
Step 2: Remove the protective paper from the foam tape
Remove the protective paper from the foam tape to expose the sticky side.
Step 3: Apply the foam tape
Apply the foam tape to all 4 sides of your blind. Make sure all sides are properly covered without any gaps.
Step 4: Insert and test the blind
Place the blind in the window opening. Test the curtain by pulling the fabric frame to the left.
