Guide for measurement

Step 1: Measuring the window's niche depth

Before you measure the width and height of your window, it is important to check the recess depth to ensure there is enough space for the covering to fit.

• Minimum recess depth required: 3 centimeters for proper installation.
• How to measure: Start at the front edge of the window recess (the part that is farthest from the window) and measure to the shallowest point within the recess.

Watch out for obstacles

Common obstacles in your window niche include:

• Window handles
• Lock fittings
• Lock mechanisms
• Cranks or crank mechanisms

Measurement with obstacles

Even if your window niche is deep, obstacles can prevent the blinds from closing properly. To ensure everything fits:

1. Measure the niche depth from the front edge of the niche to the window.
2. Measure the obstacle depth from the front of the window to the front edge of the obstacle (e.g., a handle).
3. Subtract the obstacle depth from the niche depth to determine your unobstructed space.

Important: You need at least 3 centimeters of unobstructed space to install the Guard safely.

Step 2: Measuring the width

Since windows are often not perfectly square, you need to measure the width at three different points to account for any irregularities:

• At the top of the window recess
• In the middle of the window recess
• At the bottom of the window recess

Note the smallest of these three measurements. This ensures that your Guard fits even at the narrowest point of the window.

Step 3: Measuring the height

Then measure the height of your window niche. Again, take measurements from three different places:

• Left side of the window niche
• Middle of the window niche
• Right side of the window niche

Just like with the width, note the smallest of these three measurements.

Avoid common measurement errors

To get the most accurate measurements, avoid these common mistakes:

• Measuring at an angle: Always keep the measuring tape straight and level.
• Bent measuring tape: Make sure the measuring tape is taut to get accurate measurements.
• Incorrect rounding: If necessary, round to the nearest millimeter.